Waterjet Cutting for Materials

What You Stand to Gain By Using Waterjet Cutting for Materials

About


About

Waterjet cutting is one of the methods applied for cutting of metal and other substances in an industrial setup. It makes use of an ultra-high pressure waterjet, which is sometimes used together with plasma cutting or an oxy-fuel flame to cut through matter. The waterjet machine cuts with a high degree of accuracy and this produces a very clean cut.  This the reason why it is normally preferred for cutting of materials that require minimal damage to the cut parts, and also where wastage of material is undesirable especially if such material is expensive. Industries that need to cut through metals and other hard materials to manufacture and fashion products normally use waterjet cutting. Waterjet cutting is advantageous in a number of ways. The following are just a few of these advantages. More about omax spare parts


The heat aspect associated with many cutting methods is absent from waterjet cutting. Heat  is normally produced when other ways of cutting material are used. It's the high temperatures produced by the heat that can even melt metal and cause it to separate at the point where it is applied. This is usually disadvantageous in case the material being cut is sensitive to heat. These delicate materials can easily be damaged by the heat, meaning that you cannot use them anymore. But waterjet cutting can easily be used for such materials because it works with pressure rather than heat.

There's very little wastage of material because it has a very high precision of cutting. That's why waterjet cutting is referred to as a precision cutting method. The method can make cuts as narrow as under a millimeter thick. This means that very little material will be wasted during the cutting. And the fact that it is carried out on the computer with an advanced software means that it is even more precise as compared to other cutting approaches. More about omax waterjet machines


Waterjet cutting is applicable for cutting all kinds of material. Laser and plasma cutting, as well as use of oxy-fuel flame normally involve lots of heat This implies that such methods are not suitable for cutting through materials that are either heat intolerant or soft. But waterjet cutting is quite adaptable to cut all kinds of material, which makes it very useful. https://en.wikipedia.org/wiki/Abrasive

Additionally, waterjet cutting hardly leaves any  dirt on the surface being cut. It is usually necessary to carry out an extra cleaning process on the surface cut by other methods because such surfaces are usually deformed and bent sometimes. Cutting surfaces using a waterjet machine, however, leaves them with a clean finish meaning that they require very little work to smoothen them afterward. The cleanup work is therefore considerably reduced, meaning that the industry can commit labor to other productive tasks.
This site was built using